Then, a web interface will be used for the software configuration and monitoring. I decided to test it, and was pretty amazed by the results, so I will share everything with you in this article.ĪdGuard Home is an ad-blocking solution, available for Linux and Mac, and can also be installed on Raspberry Pi with only one command line. Once Pi-hole is ready, shut down both RPi and Mikrotik, connect RPi to USB port on Mikrotik, let it boot up.Recently, I came across AdGuard Home which is a network-wide ad blocker that looks a lot like Pi-Hole on the user end.If you want to change the static assigned IP address AFTER installing Pi-hole, you can edit usb0 interface settings in /etc/nf.Install Pi-hole - instructions are here, follow the steps and you will end up with Pi with static IP address configured on it.Configure network access on the PC to allow RPi to reach the Internet - NAT or something.NOTE - This is required for RPi to show up as LTE interface on Mikrotik! Options g_ether idVendor=0x05ac idProduct=0x1402 iProduct=Pi0 iManufacturer=Raspberry On the RPi create file called /etc/modprobe.d/g_nf with the following content (single line of text).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |